功能 #2536
已关闭
功能 #2519: Ford_SYSR: System Requirement
Ford_SYSR：FS_REQ0016_V3 PWM output configuration
由 玉洁 金 在 8 个月 之前添加.
更新于 2 个月 之前.
描述
The LDM shall have 4 PWM outputs capable of controlling any of the following functions via configure parameter ‘PWMx_Function_Assign_cfg’:
• 0x00: PWM unused.
• 0x01: Follow LB request
• 0x02: Follow HB request
• 0x03: Follow TI/Hazard request
• 0x04: Follow DRL1 request(To be activated to DRL request and follow DRL bright/dim/off modes. Dim Duty Cycle in park mode, full intensity on DRL_Rqst. Follow performance control for TI activation)
• 0x05: Follow DRL2 request(To be activated to DRL request and follow DRL bright/dim/off modes. Dim Duty Cycle in park mode, full intensity on DRL_Rqst. Follow performance control for TI activation)
• 0x06: Follow Licoln Lit Star
• 0x07: Follow Front Fog(Follow Front Fog trigger strategy)
• 0x08: Follow Cornering light(Follow Cornering trigger strategy )
• 0x09: Side Marker(Follow Side Marker trigger strategy)
• 0x10: Follow Static Bending light(Follw Static Bending trigger strategy)
• 0x11-0x15: Reserved
The PWM output shall be activated immediately from 0% to ‘PWMx_Target_Duty_Cycle_cfg’ when the corresponding function is requested.
The LDM shall have 4 PWM outputs capable of controlling any of the following functions via configure parameter ‘PWMx_Function_Assign_cfg’:
• 0x00: PWM unused.
• 0x01: Follow LB request
• 0x02: Follow HB request
• 0x03: Follow TI/Hazard request
• 0x04: Follow DRL1 request(To be activated to DRL request and follow DRL bright/dim/off modes. Dim Duty Cycle in park mode, full intensity on DRL_Rqst. Follow performance control for TI activation)
• 0x05: Follow DRL2 request(To be activated to DRL request and follow DRL bright/dim/off modes. Dim Duty Cycle in park mode, full intensity on DRL_Rqst. Follow performance control for TI activation)
• 0x06: Follow Licoln Lit Star
• 0x07: Follow Front Fog(Follow Front Fog trigger strategy)
• 0x08: Follow Cornering light(Follow Cornering trigger strategy )
• 0x09: Side Marker(Follow Side Marker trigger strategy)
• 0x10: Follow Static Bending light(Follw Static Bending trigger strategy)
• 0x11-0x15: Reserved
The PWM output shall be activated immediately from 0% to ‘PWMx_Target_Duty_Cycle_cfg’ when the corresponding function is requested.
The PWM avtivation and output voltage shall base on module power supply, as functional voltage range 7-18V.
- 主题 从 Ford_SYSR：FS_REQ0016_V2 PWM output configuration 变更为 Ford_SYSR：FS_REQ0016_V3 PWM output configuration
导出 Atom
PDF